Firmware Release Notes SW01978-5.3.0.0

======================================
Supported Products:
R-PASS (A0)
SSD (B0)
Z-PASS2-RT-4G (A0)
Z-PASS2-RT-4G (B0)
Z-PASS2-RT-4G (C0)
Z-PASS2-RT-4G-S (A0)
Z-PASS2-RT-4G-S (B0)
Z-PASS2-RT-4G-S (C0)
Z-TWS4-RT-S (A0)
Z-TWS4-RT-S (B0)
Z-TWS4-RT-S (C0)
Z-PASS1-RT (A0)
Z-PASS1-RT (B0)
Z-PASS1-RT (C0)

======================================

WARNING! - MAJOR RELEASE
Firmware version 5.x can only be updated from version 4.9.0.0 or later. Updating from earlier versions may cause the device to freeze and become unusable.

Following a factory reset, the web page and discovery tool will only be available on the LAN interface. To disable the firewall, go to Router Configuration and disable the firewall for each interface, or configure a firewall exception rule to specify which ports should be open on each interface.

NEW:
- New: firewall exceptions: introduction of a policy based on source IP address and/or MAC address
- New: introduction of a “capability-based access control system”:
ability to associate the following capabilities with different user types (“admin,” “user,” “operator”): 
“Network Configuration,” “System Administration,” “Tag, Logic, and Data Logger,” “Maintenance” with the following levels:
  “No Access,” “Read Only,” “Read/Write”
- New: Web Pages: Renamed the ‘Guest’ user type to “User”
- New: Security Status: added the following to “unsecure protocols”:
  - OPC-UA Server with “Security Policy”=None
  - Wi-Fi (Station, AP), with “Encryption Type”=None, WEP

FIX
- Fix: corrected an error where the configuration checksum was not updated after loading or deleting a logic rules script