Release Notes Firmware SW01978-5.0.0.2

======================================
Supported Products:
R-PASS (A0)
SSD (B0)
Z-PASS2-RT-4G (A0)
Z-PASS2-RT-4G (B0)
Z-PASS2-RT-4G (C0)
Z-PASS2-RT-4G-S (A0)
Z-PASS2-RT-4G-S (B0)
Z-PASS2-RT-4G-S (C0)
Z-TWS4-RT-S (A0)
Z-TWS4-RT-S (B0)
Z-TWS4-RT-S (C0)
Z-PASS1-RT (A0)
Z-PASS1-RT (B0)
Z-PASS1-RT (C0)

======================================

WARNING! - MAJOR RELEASE 
Firmware 5.x can be updated only from release 4.9.0.0 or later. From earlier versions, the device may freeze and become unusable.

After a factory reset, the web page and discovery tool will only be available on the LAN interface. To disable the firewall, go to Router Configuration and disable the firewall for each interface, or configure a firewall exception rule to specify which ports should be open on each interface.




NEW:
- New: secure boot
- New: user management overhaul
- New: centralized session management for GUI and web pages via GUI-daemon
- New: session timeout after inactivity for web pages, SSH, and serial console
(already available for GUI)
- New: limit of one session for GUI/web pages
- New: limit of one session for SSH/serial console
- New: system usage notification message (configurable), displayed before login
- New: audit logs
- New: device decommissioning
- New: firewall review
- New: backup save/restore:
the backup contains:
- configuration
- data
- audit logs
- debug logs
the restore restores:
- configuration
- data
- New: MQTT configuration for Cloud Direl:
- “Subscribe Topic” setting if both username and password are non-empty; otherwise, it is left blank
- Replaced “%f” with “%jn” in “Publish Bulk Format”
- New: Cloud Configuration:
- New “Inuatek-DCC” cloud (same as “Direl-ADM”)
- Removed “CloudBox2” cloud
- New: Updated the APN database
- New: Updated the Seneca device database
- New: Added “audit logs” for “session timeout”, “session already active”, “login locked”


FIX:
- Fix: NAT FTP 
- Fix: Changes to resolve the issue of the browser closing without logging out: login becomes available again after a maximum of 3 minutes
- Fix: Changed the default value of the “Firewall/LAN” parameter from ‘ON’ to “ON excluding PING” to prevent discovery timeouts
- Fix: “User Configuration (ADD)” page: Added notes regarding the password
- Fix: “Firewall Exceptions” page: Only available network interfaces are displayed