Release Notes Firmware SW01978-3.2.3.0

======================================
Supported products:
R-PASS (A0)
SSD (B0)
Z-PASS2-RT-4G (A0)
Z-PASS2-RT-4G (B0)
Z-PASS2-RT-4G (C0)
Z-PASS2-RT-4G-S (A0)
Z-PASS2-RT-4G-S (B0)
Z-PASS2-RT-4G-S (C0)
Z-TWS4-RT-S (A0)
Z-TWS4-RT-S (B0)
Z-TWS4-RT-S (C0)
Z-PASS1-RT (A0)
Z-PASS1-RT (B0)
Z-PASS1-RT (C0)

======================================

ATTENTION! There are two different .BIN files in the compressed file. Please check the firmware on the device to be updated and use the correct “.bin” file:
- SW012400_chm.bin = to update a device using firmware FW01240-x.x.x.x
- SW01978_xxxx.bin = to update a device using firmware FW01978-y.y.y.y
If in doubt, contact the support team by email at support@seneca.it

ATTENTION! After resetting to factory settings, the Straton PORT is 1100 (no longer 502).


NEW:
- Added 32-bit counter management on digital inputs, with “retain” tag
- FeRAM cleaning on factory reset
- Straton:
- Added counter management to I/O profiles for Z-PASS-RT and R-PASS
- Added I/O profile for SSD-S
- Added SET_COUNTER_VAL function to the Seneca Library


FIX:
- “Tag Setup” page: corrected management of the RETAIN=ON option with PLC_Mode=None
- “Tag Setup” page: fixed a problem related to the presence of spaces in tag names in the Seneca device DB
- changed the default value of the “PLC Configuration”/“Retain Variables Enable” parameter from ON to OFF (used with PLC_Mode=Shared)
- “I/O Configuration” page: removed the “Remote Toggle” option